Replacing A Drive Belt; Maintenance And Cleaning; Service Centre; Warranty - Parkside PEH 30 A1 Bedienungs- Und Sicherheitshinweise

Preparing for use / Maintenance and cleaning / Service centre / Warranty
The planer blade 20 has two cutting edges and it
can be fitted either way around.
Replace the planer blade
edges are blunt.
Do not resharpen the planer blades
Reversing or replacing a planer blade
IMPORTANT INFORMATION:
Do not release the two Allen keys. They are used to
adjust the height of the blade shaft.
Adjustment is necessary only if you wish to use a
different planer blade type e.g. a profiled blade.
Always replace both blades at the same time to
avoid out of balance forces.
NOTE: If you only release one blade first then you
can use the factory-fitted second blade for orientation
when you fit the new blade.
1. Release the 3 bolts of the cutting element
using the supplied open spanner
Press the removable side guard
in the housing.
2. Push the cutting element
the blade shaft .
17
3. Push the planer blade
the cutting element
18
4. Reassembly is carried out in the reverse order
with a reversed or new planer blade.
5. Planer blades can be obtained from the
20
service address indicated (see section about

warranty).

©

Replacing a drive belt

(see Figs. F + G)
DANGER OF INJURY!
Before you carry out any work on the device always
pull the mains plug out of the mains socket.
Release the screws
cover .
4
Remove the worn drive belt
First place the new drive belt
belt wheel and then pull the drive belt
25
on to the large belt wheel
32 GB
when both cutting
20
.
20
20
18
.
26
into the slot
21
sideways out from
18
20 sideways out from
.
and remove the belt
5
23 .
on to the small
23
23
24 by rotating it.
Put the belt cover 4
fasten it into place with the screws
©

Maintenance and cleaning

DANGER OF INJURY!
Before you carry out any work on the device always
pull the mains plug out of the mains socket.
Always keep the device and the ventilation
slots clean. This way you will work more safely
and produce better results.
Clean out the planing debris removal port
regularly.
Clean out a blocked planing debris removal
port using suitable means (e.g. piece of wood,
air under pressure, etc.).
Use a dry cloth to clean the housing.
Remove any adhering planing dust with a
narrow paint brush.
In no circumstances use sharp objects, or petrol,
solvents or cleaning agents that might attack
plastic. Do not allow any liquids to enter the
inside of the device.
©

Service centre

Have your device repaired
only by qualified specialist personnel
using original manufacturer parts only.
This will ensure that your device remains safe
to use.
If the plug or mains lead
needs to be replaced, always have
the replacement carried out by the
manufacturer or its service centre. This
will ensure that your device remains safe to use.
©
Warranty
The warranty for this appliance is for 3 years
from the date of purchase. The appliance
has been manufactured with care and me-
ticulously examined before delivery. Please
retain your receipt as proof of purchase. In
back into position and
.
5
3