Replacing The Drive Belt (See Fig. F); Maintenance And Cleaning; Disposal - Parkside PEH 30 C3 Gebrauchsanweisung, Originalbetriebsanleitung

NOTE
► The planing blade
with protective lacquer. It is not necessary to
re-bond the blade.
♦ Fit either a new or turned blade in the reverse
order. Make sure that the notch on the planing
blade slides into the tensioning plate groove
(see fig. E).
20a
♦ Planing blades can be purchased exclusively
from the address given below (see section "Ser-
vice"). Do not use planing blades from other
manufacturers.
Replacing the drive belt (see fig. F)
WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance.
♦ Remove the screws
belt cover .
♦ Remove the worn drive belt
♦ Fit the new drive belt
wheel first and then turn the drive belt
and pull it onto the large belt wheel
♦ Replace the drive belt cover
place using the screws

Maintenance and cleaning

WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance.
♦ Keep the appliance and the ventilation slits
clean to ensure fault-free operation.
♦ Clean the chip ejector
♦ To clean a blocked chip ejector, use a suitable
tool (e.g. a piece of wood, compressed air,
etc.).
♦ Use a dry cloth to clean the housing.
♦ Use a brush to remove any dust stuck to the
appliance.
│ GB │ MT
■ 44
may be factory-bonded
and detach the drive
.
onto the small belt
.
and fix it in
.
regularly.
♦ Never use sharp objects, petrol, solvents or
cleansers which can damage plastic. Do not
allow any liquids to get into the interior of the
appliance.
NOTE
► Spare parts which are not listed (e.g. carbon
brushes, planing blades) can be ordered
exclusively via our Service Hotline.

Disposal

The packaging consists of environmentally
friendly material. It can be disposed of in
the local recycling containers.
Do not dispose of power tools in
your normal domestic waste!
European Directive 2012/19/EU requires that
worn-out power tools be collected separately and
recycled in an environmentally compatible manner.
Your local community or municipal authorities can
provide information on how to dispose of the ap-
pliance.
Dispose of the packaging in an
environmentally friendly manner.
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary.
The packaging material is labelled
with abbreviations (a) and numbers
(b) with the following meanings:
1–7: Plastics,
20–22: Paper and cardboard,
80–98: Composites
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out
product.
PEH 30 C3