♦
Push the planing blade
clamping element
NOTE
►
The planing blade
with protective lacquer . It is not necessary to
re-bond the blade .
♦
Fit either a new or turned blade in the reverse
order . Make sure that the notch on the planing
blade
slides into the tensioning plate
groove
(see fig . E) .
20a
♦
Make sure that the planing blade
a little way (approx . 1 mm) from the cutter
block
in the direction of the movable lateral
cutter block guard
block to check that the planing blade does not
touch anything .
♦
Also ensure that the clamping element
closes flush to the cutter block
element
must contact the hex screws
before the fastening screws
ened .
♦
Planing blades
can be purchased exclusively
from the address given below (see section
"Service") . Do not use planing blades from
other manufacturers .
Setting the planing blade height
♦
Set the cutting depth to 0 mm .
♦
Check the position of the planing blade
both ends . Use a flat, straight object as a guide
strip over the plane sole
♦
The tip of the planing blade
with the surface of the plane sole
♦
The height of the planing blade
adjusted using the hex key
screws
. Adjust the two hex screws
18a
the tip of the planing blade is flush with the
plane sole
on both sides .
PEH 30 C3
sideways out of the
(see fig . D)
may be factory-bonded
protrudes
. Carefully turn the cutter
. The clamping
18a
can be tight-
at
.
must be flush
.
can be
via the two hex
so that
18a
Replacing the drive belt (see fig . F)
WARNING! RISK OF INJURY!
►
Always remove the plug from the power
socket before working on the appliance .
♦
Remove the screws
belt cover
.
♦
Remove the worn drive belt
♦
Fit the new drive belt
wheel
first and then turn the drive belt
and pull it onto the large belt wheel
♦
Replace the drive belt cover
place using the screws
Maintenance and cleaning
WARNING! RISK OF INJURY!
►
Always remove the plug from the power
socket before working on the appliance .
♦
Keep the appliance and the ventilation slits
clean to ensure fault-free operation .
♦
Clean the chip ejector
♦
To clean a blocked chip ejector, use a suitable
tool (e .g . a piece of wood, compressed air,
etc .) .
♦
Use a dry cloth to clean the housing .
♦
Use a brush to remove any dust stuck to the
appliance .
♦
Never use sharp objects, petrol, solvents or
cleansers which can damage plastic . Do not
allow any liquids to get into the interior of the
appliance .
NOTE
►
Spare parts which are not listed (e .g . carbon
brushes, planing blades) can be ordered
exclusively via our Service Hotline .
and detach the drive
.
onto the small belt
.
and fix it in
.
regularly .
GB │ IE │ NI │ CY
│
9
■