B. Braun Aesculap Spine activ C FW645R Gebrauchsanweisung/Technische Beschreibung Seite 15

Stage I
Fully immerse the product in the cleaning/
disinfecting solution for at least 15 minutes.
Ensure that all accessible surfaces are moistened.
Clean the product under running tap water with a
suitable cleaning brush where necessary for as long
as it takes to remove all discernable residues.
Use a suitable cleaning brush (TA011944) to clean
all surfaces which are not visible, e.g. in
instruments with concealed crevices, lumens or
complex geometries, for at least 1 min or until no
further residues can be removed.
Mobilize non-rigid components, such as set
screws, joints, etc. during cleaning.
Thoroughly rinse through these components with
the cleaning disinfectant solution (at least five
times), using a disposable syringe (20 ml).
Do not use metal cleaning brushes or other
abrasives that would damage the product surfaces
and could cause corrosion.
Stage II
Rinse/flush the product thoroughly (all accessible
surfaces) under running water.
Mobilize non-rigid components, such as set
screws, joints, etc. during rinsing.
Drain any remaining water fully.
Stage III
Fully immerse the product in the disinfectant
solution.
Mobilize non-rigid components, such as set screws,
joints, etc. during disinfection.
Rinse lumens at least 5 times at the beginning of
the exposure time, using a disposable syringe
(20 ml) and an appropriate rinsing adapter. Ensure
that all accessible surfaces are moistened.
Stage IV
Rinse/flush the product thoroughly (all accessible
surfaces).
Mobilize non-rigid components, such as set screws,
joints, etc. during final rinse.
Rinse the lumens at least five times using a
disposable syringe (20 ml) and a suitable irrigation
adapter.
Drain any remaining water fully.
Stage V
Dry the product with a lint-free cloth or medical
compressed air.
13