SolarV EPEVER UPower-Hi Serie Betriebsanleitung Seite 74

Step5: Remove the inverter/charger and drill an M10 hole according to the position
determined in step4. Step6: Insert the screw of the M8 bolt and the steel pipe into the
M10 hole.
Step7: Install the inverter/charger and secure the nuts with a sleeve.
2.5 Wiring
Remove the terminal cover
1)
Remove covers of the AC output /AC input/utility input terminal with a screwdriver, as shown
below:
Remove the inverter/charger cover
2)
Remove the screws beside the inverter/charger with a screwdriver, as shown below:
www.solarv.de
15
Copyright © 2021 SolarV GmbH All rights reserved
EN