Masterpro FRYCOOK Bedienungsanleitung Seite 20

EN
PARTS & ACCESSORIES
LID-TOPVIEW
Float Valve
Steam Release Switch
Pressure Release Valve
Lid Handle
FRONT
Base
LCD Display
Your One Touch Quick pot has been shipped with parts and accessories as shown above.Check
everything carefully before use. If any part appears damaged, do not use this product and contact
Customer Service using the number located in the back of this manual.
LID-UNDERSIDE
(WITHOUT INNER LID)
Locking Pins
STAINLESS STEEL INNERPOT
4 XC
FULL
5
CUP
The Max Fill Line in the
Inner Pot is
represented by "FULL
CUP" on some models
and "MAX" on other
models. DO NOT fill
past the Max Fill Line.
37
ASSEMBLY INSTRUCTIONS
PRESSURE RELEASE VALVE ASSEMBLY
NOTE: Do not attempt to assemble or disassemble the Pressure Release Valve when the Power
Quick Pot is in use.
• Pull to remove the Pressure Release Valve (see Fig. ix).
• Ensure that the Pressure Release Valve and holes are
not blocked by food or debris. If blocked, wash out or use
a pin to unblock.
• Look at the clip on the underside of the Pressure
Release Valve (see Fig. x). It should not be damaged or
severely bent.
• Press the Pressure Release Valve back into the hole on
the Lid. If the Valve does not insert correctly, it may have a
bent clip.
INSTRUCTION FOR USE
A. PREPARING FOR USE
CHECK PARTS & ACCESSORIES
1. Before using, remove all the parts and accessories from package and ensure all parts have been
included before discarding any packaging materials. Remove all packing materials such as plastic
film, cardboard, and stickers on the Pressure Release Valve and Condensation Collector (see
PARTS & ACCESSORIES).
2. CLEAN INSIDE: Remove the Inner Lid from Lid by pulling metal knob. Remove Rubber Gaskets
from Inner Lid (see INNER LID ASSEMBLY). Wash Inner Lid, Rubber Gasket, Inner Pot, and other
loose accessories with warm, soapy water, rinse and dry.
NOTE: Ensure to replace Rubber Gaskets (see CHANGING THE INNER LID RUBBER GASKETS
AND FLOAT VALVE ASSEMBLY sections) before reinstalling Inner Lid.
CONDUCT TEST RUN WITH WATER ONLY
FIG. A FIG. B
(Float Valve Rubber Gasket) (Condensation Collector)
1. To check that the Unit will operate properly, it is recommended to periodically check its operation
without cooking food.
2. Place the One Touch Quick pot on a clean, flat surface.
3. Attach Condensation Collector to side of the Unit by sliding it into the slots (see Fig. A).
NOTE: The Condensation Collector may be preas- sembled.
FIG. ix
38
EN
FIG. x