Setup; Operation; Connecting Headphones; Inserting/Changing The Remote Control Batteries - Renkforce 2356115 Bedienungsanleitung

8. Setup

When selecting the setup location, take the room layout into consideration (e.g. location of the nearest socket).
Avoid proximity to direct sunlight, vibrations, dust, hot and cold temperatures and damp. The device must not be
placed next to powerful transformers or motors.
Do not drill extra holes or screw any extra screws for mounting purposes into the housing. This will damage
the device.
Ensure that the device is placed on a stable surface to prevent it from falling off and causing injury.
Given the variety of paints and varnishes used to coat furniture, it cannot be ruled out that the device feet
could leave visible traces on furniture due to a chemical reaction. Do not place the device on top of valuable
furniture without appropriate protection.
Place the device on a flat, level surface that can support its load.

9. Operation

a) Connecting headphones
You can connect headphones to the
• Connect the headphones plug to the
• If the jack plug does not fit into the socket, use an adapter.
Once headphones are connected to the
The sound is only played back via the headphones.
b) Inserting/changing the remote control batteries
• Open the battery compartment on the back of the remote control.
• Insert two new 1.5 V Micro/AAA batteries with correct polarity into the battery compartment. The correct polarity is
shown in the battery compartment.
• Close the battery compartment again.
• If the remote control no longer functions or its range decreases, the batteries are discharged and must be replaced.
jack (12) if required.
jack (12).
jack (12), the built-in speakers of the device are switched off.
49