Initial Setup - Renkforce IR1 Bedienungsanleitung

9. Initial setup

At first activation of the device, or if you had disconnected it from the mains completely, "Renk-
force" will appear in the display after connection to the supply voltage. The starting process
takes a few seconds. The status is displayed by a charging bar.
If you want to change the following configurations later, you can find them in the menu item
"Configuration". The individual subitems are "Language" and "Network".
First, a menu window for the language setting is displayed after the first start.
• Select your desired language with the buttons C9 (up) and C10 (down) on the remote control or with the
dial switch A8 at the device.
• Confirm with the button C13 or A8.
Next, you will see the query of whether you want to check the WiFi connection at each activation.
• Choose "YES" or "NO" with the C11 (left) or C12 (right) button with A7 and A9.
• Confirm with the button C13 or A8 again.
In the next display, you can set up the WiFi connection. Here, you can choose between "NO", "Yes(WPS)"
and "YES". Make your selection again with the buttons C11 (left) or C12 (right) or A7 or A9 and confirm with
C13 or A8.
• Select "NO" if you want to set up the WiFi connection later.
• Select "Yes(WPS)" if you want to set up the connection with the help of WPS.
Once you have confirmed, start WPS on your router or access point as well. You have 120 seconds for
this.
The connection is then established automatically and the radio switches to the main menu.
• Select "YES" is you want to set up the WiFi connection manually.
The internet radio will automatically scan for available WiFi networks.
Select your desired WiFi with the buttons C9 (up) or C10 (down) or with the dial switch A8 and confirm
with the button C13 or A8.
Now you need to enter the WiFi password. This is easiest with the buttons 0 to 9 (D0 to D9). Use the
characters list from chapter 7. b).
Push the individual number buttons repeatedly until the desired number or letter is displayed. To switch
to the right and the next character of the password, push the respective button C12 or A9 (right). If you
want to delete the last input, do so with the C11 or A7 (left) button.
Alternatively, you can also switch through the letters and numbers with the C9 (up) or C10 (down) button
or scroll through with the dial switch A8.
To accept the password, confirm with the button C13 or A8.
The connection is then established automatically and the radio switches to the main menu.
45