Operation; Initial Setup - Renkforce RF-DAB-IR-1700 Bedienungsanleitung

10. Operation

a) Initial Setup
Connection via network cable
If the device is connected to your router via a network cable, the initial network setup is automatic. The main menu is
displayed directly after the boot process.
DHCP must be activated on your router (see the instructions for your router).
Connection via WLAN
When the device is switched on for the first time, or if you have previously reset it to the factory settings, the
following message appears on the display (5) after switching on. The starting process takes a few seconds.
• Select "YES" with the BACK
remote control.
• Confirm the selection by pressing the rotary knob TUNE/SELECT (9) or the OK (30) button on the remote control.
• In the next screen, select "Add/Remove AP" and confirm the entry as described above.
Connect using the WPS button (easy way)
• On the next screen, select "Add AP (WPS button)" and confirm again as described above.
• Press the WPS button on your wireless router to connect.
Connect by entering the network key (if there is no WPS function on the WLAN router)
• On the next screen, select "Add AP (Scan)" and confirm again as described above.
• The radio device will now look for all available wireless routers nearby and lists them.
• Select the desired WLAN router and confirm the entry.
• Enter the network key of your wireless router. Use either the 10-key (18) on the remote control or turn the TUNE/
SELECT knob (9) to select the required digits and characters.
46
(7) or FORWARD (8) buttons or the corresponding arrow buttons (20) on the
Add/Remove AP
AP:[ ]