Navkom Bioreader Bedienungsanleitung Seite 52

EN
PERFORMING FUNCTIONS BY REMOTE CONTROL
ENROLLMENT PROCEEDURE OF ADMINISTRATOR FINGERPRINTS
1
FINGERPRINTS, PRESS BUTTON
REMOTE CONTROL.
The blue LED will start blinking.
OPTIONAL STEP: ASSIGNING RELAY 2
THIS STEP SHOULD BE SKIPPED IF THE FINGERPRINT SHOULD ONLY OPEN THE DOOR
2a
IF THE ADMINISTRATOR FINGERPRINT SHOULD TRIGGER RELAY 2, PRESS
BUTTON A.
The orange LED will flash in a combination with a beep. The enrolled administrator fingerprint
will only trigger relay 2.
2b
IF THE ADMINISTRATOR FINGERPRINT SHOULD OPEN THE DOOR AND
TRIGGER RELAY 2 AT THE SAME TIME, PRESS BUTTON B.
The orange LED will flash twice in a combination with two beeps. The enrolled administrator
fingerprint will open the door and trigger relay 2 at the same time.
3
THE FINGER SHOULD BE PLACED ON THE SENSOR.
SUCCESSFUL ENROLMENT WILL BE CONFIRMED BY A
FLASH OF A GREEN LED, ACCOMPANIED BY A SHORT
BEEP.
IF A DAMAGED OR AN EXTREMELY NON-
PROMINENT FINGERPRINT WILL TRY TO BE
ENROLLED, THE RED LED WILL FLASH 5 TIMES,
ACCOMPANIED BY 5 BEEPS AND THE OPERATION
WILL BE TERMINATED. A QUALITY, CLEAN AND
SUFFICIENTLY MOIST FINGERPRINT SHOULD BE
CHOSEN FOR ENROLMENT.
98
*
READ ALSO THE CHAPTER:
»ADMINISTRATOR FINGERPRINTS«.
TO START ENROLING ADMINISTRATOR
A ON THE
1 x
1
TO START ENROLING A USER'S FINGERPRINT, BUTTON
UNIT SHOULD BE PRESSED.
The blue LED will start blinking.
BLUE
ORANGE OPTIONAL STEP: ASSIGNING RELAY 2
1x
THIS STEP SHOULD BE SKIPPED IF THE FINGERPRINT SHOULD ONLY OPEN THE DOOR
3
BLUE AND GREEN LEDS WILL FLASH ALTERNATELY.
ORANGE
THE FINGER SHOULD BE PLACED ON THE SENSOR
2x
UNTIL THE GREEN LED FLASHES AND A SHORT BEEP IS
HEARD, WHICH MEANS THE FINGERPRINT HAS BEEN
ENROLLED.
A
IF A DAMAGED OR AN EXTREMELY NON-
PROMINENT FINGERPRINT WILL TRY TO BE
ENROLLED, THE RED LED WILL FLASH 5 TIMES,
GREEN ACCOMPANIED BY 5 BEEPS AND THE OPERATION
1x
WILL BE TERMINATED. A QUALITY, CLEAN AND
SUFFICIENTLY MOIST FINGERPRINT SHOULD BE
CHOSEN FOR ENROLMENT.
USER ENROLLMENT PROCEDURE
A
2
ADMINISTRATOR FINGERPRINT IS VERIFIED FIRST.
For security reasons an admnistrator fingerprint is
needed to start the user enrolment procedure. When
the administrator finger will be recognized, the green
LED will flash, accompanied by a beep.
If a non-administrative finger will be placed on the
sensor, the device will not react and the blue LED will
keep flashing.
Follow the steps on the previous page.
EN
ON THE CONTROL
BLUE
A
GREEN
1x
BLUE
1x
BLUE
GREEN
U
GREEN
1x
99