Storage And Transport; Troubleshooting - CMi C-B-RM-40 Originalbetriebsanleitung

– Check the electrode for discolouration.
Standard colour: light brown
– Check the electrode distance with a feeler
gauge. Correct distance: 0,457-0,61 mm
Cleaning the spark plug
NOTICE! Risk of product damage!
To clean the spark plug, use only wire
brushes with brass bristles. Bristles of
any other material will damage the
electrode!
– Remove rust from the electrode with a
wire brush.
Replacing the spark plug
NOTICE! Risk of product damage!
Fit the spark plug only when motor is
cold.
– Insert a cleaned or new spark plug and
tighten by hand.
– Hand-tighten the screwed-in spark plug,
then use the spark plug wrench to firmly
tighten by another quarter turn, tightening
any more will damage the threads.
– Replace the spark plug connector (13)
firmly on the spark plug.
Fault/malfunction
Motor does not start.
Motor misfires when running
Motor does not reach the max-
imum speed

Storage and transport

Storage
– Clean the product prior to storage.
– Store the product in a dry, well-ventilated
Transport
– Use the original packaging to ship when-

Troubleshooting

If something doesn't work...
Malfunctions are often caused by minor
faults. You can easily remedy most of these
yourself. Please consult the following table
before contacting the vendor. You will save
yourself a lot of trouble and possibly money
too.
Cause
Tank empty?
Ignition cable connector
loose?
Spark plug contaminated?
Spark plug defective?
Excess fuel in the combustion
chamber?
Distance from electrode to
spark plug too great?
Incorrect fuel?
Air filter contaminated?
Spark plug contaminated?
Distance from electrode to
spark plug too great?
DANGER! Risk of injury! Store the
product so that it cannot be started up
by unauthorised persons.
Ensure that nobody can injure them-
selves on the product while it is sta-
tionary.
NOTICE! Risk of product damage!
Do not store the product unprotected
in a humid environment.
place.
ever possible.
DANGER! Risk of injury! Improper
repairs can result in the product func-
tioning unsafely. This endangers
yourself and your environment.
Remedy
► Filling with fuel – p. 42
Push the connector firmly onto
the spark plug.
► Replacing the spark plug –
p. 45
Take out the spark plug and dry
the electrode.
Set gap at 0,457-0,61mm.
Drain tank and fill up with the
correct fuel.
► Replacing the air filter –
p. 44
► Replacing the spark plug –
p. 45
Set gap at 0,457-0,61mm.
GB
45