Faq - Telecom Behnke 20-0001E Anleitung

fAQ

6.
Door dials no or wrong telephone number
▸
Telephone number not configured
▸
Wrong telephone number configured
▸
Door intercom device has not accepted the set-up, cf.: Door intercom device cannot be configured
▸ Remote station in the house rings once, no voice call
and after the telephone number
Door intercom device cannot be configured remotely
▸
The telephone with which you are configuring the door intercom device does not send any DTMF
tones Use telephone with DTMF tone
▸ Correctly enter the set-up mode with **0000
No (direct) voice call after connection
▸
Check a / b port Port in the telephone system must be generated as telephone port, not as TFE/
door intercom device/FTZ
No busy tone after ending the call
▸
Check a / b port, there is no busy tone, but the telephone system must send a busy tone after the
end of the call. Telephone system must send a busy tone when ending the call.
www.behnke-online.com
Anleitung Türstationen a / b Serie 20 / 40 / 50
*2 (pause for 2 seconds) configure before
GB
FAQ
41