Switching Off Additional Output (Optional, Only Pro D2I/Pro D3I) - Sentiotec Pro D Montage- Und Gebrauchsanweisungen

Instructions for use for the user
Using the optional control panel "Additional output control panel Pro D"
The optional control panel enables the switching on and off of the additional
output as well as the dimming or changing of the temperature. The additional
output can only be activated if the control unit is already switched on.
1. The additional output is switched on and off using the On/Off button A.
► The additional appliance switches on.
► The display a lights up on the control panel.
2. Set the desired power of the additional output with the plus button B and
the minus button C.
► The set value is displayed in the form of points (see a "9.5. Additional
output control panel Pro D (optional)" on page 47).
At "Room temperature regulation of the additional output" the temperature
can only be set in 7 steps, these correspond to the following temperatures:
Intensity
1
2
3
4
5
6
7
10.10. Switching off additional output
(optional, only Pro D2i/Pro D3i)
1. Select the additional output symbol 5 by pressing the mode button D.
Then briefly press the On/Off button A.
► The additional device switches off.
► The display 1 shows "oFF"
corresponds to tempera-
ture regulation of infra-
red heater panels [°C]
30
33
35
38
40
42
45
corresponds to tempera-
ture regulation of radiator
30
35
40
45
50
55
60
p. 54/70
[°C]
30
37
43
50
57
63
70