Endress+Hauser Proline Prosonic Flow P 500 Installationsanleitung Seite 20

EA01368D
6. Push down the tensioning screw and tighten strapping band 1 so it cannot slip.
7. Strapping band 2: proceed as for strapping band 1 (steps 1 to 6).
8. Only slightly tighten strapping band 2 for final mounting. It must be possible to move
strapping band 2 for final alignment.
9. If necessary, shorten both strapping bands and trim the cut edges.
WARNING
L
Risk of injury!
‣
To avoid sharp edges, trim the cut edges after shortening the strapping bands. Wear
suitable gloves and protective goggles.
1
 5 Holder with strapping bands (medium nominal diameters), with hinged screw
1 Mounting bolts
2 Strapping band
3 Tensioning screw
1
 6 Holder with strapping bands (medium nominal diameters), without hinged screw
1 Mounting bolts
2 Strapping band
3 Tensioning screw
20
2
2
3
3
Endress+Hauser