Endress+Hauser Proline Prosonic Flow P 500 Installationsanleitung Seite 12

EA01368D
6. Project and draw the center line onto the rear of the measuring pipe.

7. Mark the drill hole on the rear center line.
8. Cut out the second drill hole and prepare holes for welding in the sensor holders
(deburr, clean).

9. Insert sensor holders into both drill holes. To adjust the welding depth, both sensor
holders can be secured with the special tool for regulating the insertion depth
(optionally available ) and then aligned with the path rod. The senor holder must be
flush with the inside of the measuring pipe.
10. Spot-weld both sensor holders. To align the path rod, screw both guide bushes into the
sensor holders.

11. Weld in both sensor holders.
12
a
Endress+Hauser