Endress+Hauser Proline Prosonic Flow P 500 Installationsanleitung Seite 14

EA01368D
4. Cut the first drill hole using a plasma cutter, for example. Measure the wall thickness of
the measuring pipe, if not already known.

5. Determine the sensor distance and arc length →  9.
6. Use the arc length that was determined to correct the center line.

7. Project and draw the corrected center line onto the opposite side of the measuring pipe
(half of measuring pipe circumference).
8. Mark the sensor distance on the center line and project it onto the center line on the
rear of the pipe.

14
b
a
Endress+Hauser