Athena GET 2ND INJ. KIT Installationsanleitungen Seite 4

3. Cut the GET fuel hose provided in the kit to 400 mm / 15.75".
The remaining part will not be used.
GET fuel hose
4. Connect hoses A and B to the 3-way fitting using the Ø 12
mm / 0.47" hose clamps. Connect hose C to the 3-way fitting
using the Ø 13 mm / 0.51" hose clamp.
D. 2nd INJECTOR KIT INSTALLATION
2ND INJECTOR ASSEMBLY
1.
Place the second injector support bracket over the
inner layer of the manifold. Place the second injector
support fixing bracket outside the manifold then fix it
to the second injector support bracket with the supplied
screw. Seal the manifold surfaces with a silicone sealant.
We suggest applying Athena's Athesil RTV silicone sealant
(not included in the box).
2.
Assemble the fuel
rail and GET second
injector over the
second injector support
bracket. Fix everything
with the supplied screws
and washers.
ATTENTION: TO AVOID DAMAGING INJECTOR
O-RING, APPLY GREASE ON IT.
EN
400 mm / 15.75"
C
To GET 2nd Injector
Outside
Inside
6
3.
Re-install the manifold, now equipped with GET 2nd
injector, and the rear subframe.
2ND INJECTOR KIT INSTALLATION
1.
Connect the end of
hose A to the OEM injector.
2.
Connect the end of
hose C to GET fuel rail
using a provided hose
clamp. Install the hose
by passing it over the
rear shock absorber,
specifically where the
rear shock absorber
attaches to the frame in
order to avoid the fuel
hose to collide with it.
3.
Move the ECU harness
from the left to the right
side of the rear shock
absorber. Remove the
protective cap from the
"INJ2" GET ECU connector
and plug it to the female
second injector harness
connector.
A
To OEM injector
C
Second
GET
injector
harness ECU
7 EN