Athena GET 2ND INJ. KIT Installationsanleitung Seite 7

D. 2ND INJECTOR KIT INSTALLATION
2ND INJECTOR ASSEMBLY
1.
Place the second
injector support fixing
bracket
manifold and align it
to the four Ø 4 mm
/ 0.16" holes milled
previously.
provided screws in the
four holes and fix the
second injector support
bracket outside
manifold.
four nuts on the screws
without tightening them
completely.
ATTENTION:
For a perfect seal on the manifold, tighten the nuts
provided in GET kit only after the installation of GET
second injector.
2.
Install GET second
injector and its seal on
the 2nd injector support
bracket. Do not forget the
O-ring. Tighten the nuts.
inside the
Place the
the
Place the
7
gk-inj2-001
Outside
Inside
EN