Athena GET 2ND INJ. KIT Installationsanleitung Seite 6

FUEL HOSES
1. Remove the OEM fuel hose. Check in your motorbike's
workshop manual where to find it. Cut the OEM fuel hose to the
following measure (consider fuel couplings in the measures):
A (OEM injector side): 80 mm / 3.15"
B (Fuel pump side): remaining OEM fuel hose length
Shorten the B hose by 10 mm /0.39". This chunk will not be used.
80 mm / 3.15"
To OEM injector
2. Cut the provided GET fuel hose to 300 mm / 11.81". Any
residual material from GET fuel hose will not be used.
3. Assemble hose A and B using the 3-way fitting included in
the kit. Fix the hoses using the hose clamps included in the box.
4. Using a cutter, shorten the
free outlet of the 3-way fitting
(see picture). This may help the
installation of GET fuel hose on
the 3-way fitting. Fix this hose
with a hose clamp as well.
EN
10 mm / 0.39"
A
6
B
To the fuel pump