AsViva MG5 Betriebsanleitung Seite 39

ASSEMBLY
STEP 2
1. First slide the rubber buffers (54-1) from below onto the guide rods (7). Insert the guide rods (7) into
the holes of the rear connecting frame (1) and fasten them with two bolts (56-3) and two washers
(56-12).
2. Slide the individual weight plates (57) into the guide rods (7). Now guide the selection rod (8)
through the center hole.
3. Now place the head piece (9) on the guide rods (7) and the selection rod (8). Please test, if the bolt
pin (53-5) can be inserted into each weight plate. Place the Weigt Plate Washer onto the head of
selector stem (9) and secure it with bolt (56-4) and nut (56-14).
39