Preparing The Wet/Dry Vacuum Cleaner For Use; Assembling The Wet/Dry Vacuum Cleaner; Attaching Accessories - Stihl SE 33 Gebrauchsanleitung

5 Preparing the wet/dry vacuum cleaner for use

► If the wet/dry vacuum cleaner needs to be
serviced or repaired: Contact a STIHL
dealer.
5 Preparing the wet/dry vac‐
uum cleaner for use
5.1 Preparing the wet/dry vacuum
cleaner for use
The following steps must be performed before
commencing work:
► Make sure that the wet/dry vacuum cleaner
and the connecting cable are in a safe condi‐
tion, 4.6.
► Clean the wet/dry vacuum cleaner,
► Attach the suction hose,
► Check the cartridge filter,
► If using an accessory: Fit accessory,
► Plug the mains plug of the wet/dry vacuum
cleaner into an easily accessible socket.
► If it is not possible to carry out these steps: Do
not use the wet/dry vacuum cleaner. Consult a
STIHL dealer.
6 Assembling the wet/dry
vacuum cleaner
6.1 Assembling the Wet/Dry Vac‐
uum Cleaner
The accessory supplied is inside the cardboard
box and inside the container.
2
1 1
► Release the container locks (1).
► Lift off the top part (2).
► Remove the accessory.
► Replace the top part (2) in position.
► Fasten the container locks (1).
0458-889-9821-B
13.
6.2.1.
8.
6.3.
Attaching the front/rear wheels
2
1
► Push the front wheels (1) into their seat (2) as
far as they will go.
► Push the rear wheels (3) into their seat (4)
with a rotary movement.
The rear wheels engage audibly.
6.2 Fitting and removing suction
hose
6.2.1 Attaching the Suction Hose
2
1
► Push the sleeve (1) into the suction connec‐
tor (2) until it sits firmly.
6.2.2 Removing the Suction Hose
► Pull the sleeve out of the suction connector.
6.3

Attaching accessories

4
3
► Fit the suction pipe (2), crevice nozzle (3) or
floor nozzle (4) onto the suction hose (1).
English
3
4
1
2
21