Preparing The Wet/Dry Vacuum Cleaner For Use; Assembling The Wet/Dry Vacuum Cleaner; Fitting And Removing Suction Hose - Stihl SE 33 Gebrauchsanleitung

English
5 Preparing the wet/dry vacuum cleaner
for use
5.1

Preparing the wet/dry vacuum cleaner for use

The following steps must be performed before commencing
work:
► Make sure that the wet/dry vacuum cleaner and the
connecting cable are in a safe condition, @ 4.6.
► Clean the wet/dry vacuum cleaner, @ 13.
► Attach the suction hose, @ 6.2.1.
► Check the cartridge filter, @ 8.
► If using an accessory: Fit accessory, @ 6.3.
► Plug the mains plug of the wet/dry vacuum cleaner into an
easily accessible socket.
► If it is not possible to carry out these steps: Do not use the
wet/dry vacuum cleaner. Consult a STIHL dealer.
6 Assembling the wet/dry vacuum
cleaner
6.1

Assembling the Wet/Dry Vacuum Cleaner

The accessory supplied is inside the cardboard box and
inside the container.
2
1 1
► Release the container locks (1).
► Lift off the top part (2).
30
5 Preparing the wet/dry vacuum cleaner for use
► Remove the accessory.
► Replace the top part (2) in position.
► Fasten the container locks (1).
Attaching the front/rear wheels
2
1
► Push the front wheels (1) into their seat (2) as far as they
will go.
► Push the rear wheels (3) into their seat (4) with a rotary
movement.
The rear wheels engage audibly.
6.2

Fitting and removing suction hose

6.2.1 Attaching the Suction Hose
2
1
► Push the sleeve (1) into the suction connector (2) until it
sits firmly.
3
4
0458-889-9821-A