Turning Off The Appliance; Storing The Appliance - Kärcher SC 5.800 C Kurzanleitung

Turning on the Appliance
 Place the unit securely on a firm surface.
 Insert the mains plug into a socket.
 Rotate the selector switch to steam level
selection range from the OFF position.
Display - heater blinks green.
Note: If there is no or not enough water in
the steam boiler, the water pump starts and
supplies water from the reservoir into the
steam boiler. The filling process may take
several minutes.
 Wait until the heater display lights up
permanently.
The steam cleaner is ready to use.
Note: The appliance briefly closes the
valve every 60 seconds. This will prevent
the valve from sticking. There will be a
slight audible click. The steam delivery is
not impaired by this.
Refilling Water
In case of water shortage, the water short-
age display lights up red and a signal can
be heard.
Note: Every time there is not enough water
in the steam boiler, the pump automatically
supplies water from the water reservoir into
the steam boiler. If the water reservoir is
empty, the water pump is not able to fill the
steam boiler and the steam tapping is
blocked.
 Fill the water reservoir up to the "MAX"
marking.
Note: The water pump tries to fill the steam
boiler in short intervals. If the filling is suc-
cessful, the steam tapping is released im-
mediately, and the red display goes out.
20
Adjusting the Steam Quantity
The emerging steam is regulated by a se-
lector switch. Depending on the type of
contamination and its severity, this selector
switch offers adjustment possiblities from
the minimum steam level (slight contamina-
tion) to the max. steam level (severe con-
tamination).
For severe contamination located in difficult
to access areas, there is the vapohydro
function.
Adjusting the steam quantity
 Set selector switch to the required
steam volume.
 While operating the steam switch, al-
ways direct the steam gun at a separate
piece of cloth until the steam is emitted
evenly.

Turning Off the Appliance

 Rotate the switch to the OFF position to
turn off the appliance.
 Disconnect the mains plug from the
socket.
 Press the cover of the appliance connector
to the bottom and disconnect the steam
plug from the appliance connector.
 Empty the residual water from the water
reservoir.

Storing the Appliance

Illustration
 Store the round brush in the accessory
compartment.
 Insert the manual nozzle onto each ex-
tension pipe.
 Put the extension pipes into the large
acessory holders.
 Insert the point stream nozzle into the
accessory storage compartment.
 Hook the floor nozzle into the parking
position.
 Wrap the steam hose around the exten-
sion pipes and insert the steam pistol
into the floor nozzle.
 Stow away the mains cable in the ac-
cessory holder for the mains cable.
– 9
EN
-