Commissioning; Installing The Warewasher; Connecting The Warewasher; Water Connection - Miele PTD 901 Originalbetriebsanleitung

5

Commissioning

5.1

Installing the warewasher

The installation site must be frost-resistant to prevent the water supply systems from freezing.
Ø
Install the warewasher horizontally using a spirit level.
Ø
Adjust any unevenness of the base using the height-adjustable machine feet.
5.2

Connecting the warewasher

The warewasher and any other relevant additional devices must be connected in adherence to local standards and regulations by an
electrical company authorised by the relevant electricity supplier.

5.2.1 Water connection

The water-related safety should be as per DIN EN 61770. The warewasher can be connected to a fresh water pipe without an interme-
diate connection to other safety equipment.
Connecting the inlet water hose
Important notes:
– Do not shorten, alter or damage the inlet water hose.
– Use only the inlet water hose supplied. Old existing inlet water hoses may not be re-used.
– Do not kink the inlet water hose when connecting it.
Operating instructions PTD 901
1
2
3
1
Ø
Connect the inlet water hose (3) to the warewasher.
Ø
Connect the dirt trap (2) to the on-site water supply (1).
Ø
Connect the inlet water hose (3) to the dirt trap (2).
Ø
Open the water supply (1) and check that the connections are
sealed.
The dirt trap prevents particles from the inlet water from entering
the warewasher, thus preventing extraneous rust on the cutlery
and in the warewasher.
Connecting the warewasher to the waste water system
Ø
Connect the waste water hose (1) to the warewasher.
Ø
Guide and connect the waste water hose to the on-site waste
water connection.
| |
12020302; 2021-09
| |
Commissioning 5 English
73