Basic Operation - WIKA CPH6200-Ex Betriebsanleitung

Hand-Held Pressure Indicator
CPH6200-Ex (Atex-Version)

1.6 Basic operation

On turning the device on; if the logger function is selected, the inte-
grated clock's time will be displayed briefly. If a zero point adjustment
has been carried out, the display will indicate this by showing "nuLL-
Corr".
After changing the battery the menu for setting the clock is activated
automatically ('CLOC'). Check the clock and adjust if necessary (see
Section 2).
1. On/Off key
2. Set/Menu: Enter configuration menu (press for 2 sec)
3. Tare:
4. Store/Quit: Activate hold function or logger function (see Section 4)
5. Min/Max:
Max-Function: Pressing ´Max´ shows the maximum measured value
Min-Function: Pressing ´Min´ shows the minimum measured value
Hold-Function: By pressing ´Store/Quit´ the instantaneous measured
Logger-Functions: Activated by the ´Store/Quit´ key, only if the logger
Tare-Functions: By pressing ´Tare´, the display will be set to 0. All
WIKA Operating Instructions Hand-Held Pessure Indicator
1
2
Activate tare function, zero point adjustment
Display the respective min-/max-memory value in
lower display
recorded. Pressing it again hides it. To clear the max-
memory press the ´Max´ key for > 2 seconds.
recorded. Pressing it again hides it. To clear the min-
memory press the ´Min´ key for > 2 seconds.
value will be shown in the lower display. Pressing it
again hides it. (Only when the main menu item
logger = 'off' is selected).
has been selected via the main menu (see Section 4).
measurements from then on will be displayed relative
to the set tare value. When the tare function is activa-
ted, the arrow ´Tare´ appears in the display. To deac-
tivate the tare function press ´Tare´ for > 2 seconds.
5
5
GB
3
4
9