The Serial Interface; Available Pressure Sensors - WIKA CPH6200-Ex Betriebsanleitung

Hand-Held Pressure Indicator
CPH6200-Ex (Atex-Version)
Stopping the logging manually:
By pressing the ´Store/Quit´ key, recording can be manually inter-
rupted. The following choice then appears:
The selection can be made by key: ´Max´ and key: ´Min´.
Key ´Store/Quit´ enters the choice.
If you try to switch off the instrument during a logging cycle, you
will also be asked if you wish to stop recording. The device can
only be switched off after the recording has been stopped!
The Auto-Power-Off-function is deactivated during logging!
Clear data:
When the ´Store/Quit´ key is pressed for 2 seconds, the option to
clear the logger memory will be displayed:
The options are selected by the ´Max´ key and the ´Min´ key.
´Store/Quit´, confirms the choice.

5. The serial interface

The use of the serial interface is only permitted outside of an
explosive atmosphere.
For data transfer to a computer there are two electrically-isolated
interface adapters available for the connection of the CPH6200-Ex to a
RS-232 or USB interface (USB-driver necessary).
WIKA's Data logger evaluation software GSOFT (see current price list)
is used to display the data. To avoid transmission errors, there are
several security features implemented (e.g. CRC).

6. Available pressure sensors

The instrument has been designed so that all sensors model CPT62I0
can be connected without the need for any configuration or recalibra-
tion. There is therefore a wide range of interchangeable sensors avail-
able; with ranges of up to 1000 bar (see current price list for model
CPT62I0 pressure transmitters).
WIKA Operating Instructions Hand-Held Pessure Indicator
Stop
recording
clear all
data points
GB
Do not stop
recording
clear nothing
(cancel operation
19