Configuration; Unit) Choice Of Pressure Units; Sl) Sea-Level Correction For Absolute Pressure Sensors; Sea-Level Correction For Absolute Pressure Sensors - WIKA CPH6200-Ex Betriebsanleitung

Hand-Held Pressure Indicator
CPH6200-Ex (Atex-Version)

2. Configuration

To change device settings, press the ´Set/Menu´ key for 2 seconds.
This will access the configuration menu (main display: "SEt").
Pressing the ´Set/Menu´ key again scrolls down the menus, pressing
the ´Tare´ key scrolls across to the associated parameters, which can
then be selected with the ´Tare´ key.
The parameters can be altered using the ´Min´ or ´Max´ keys. Pressing
the ´Set/Menu´ key again saves the settings and returns you to the
main configuration menu.
The ´Store/Quit´ key exits the configuration and returns you to stand-
ard measuring mode.

2.1 (Unit) Choice of pressure units

Depending on the pressure range, the pressure value can be displayed
in any one of the following units: mbar, bar, Pa, kPa, MPa, mmHg or
psi.

2.2 (SL) Sea-level correction for absolute pressure sensors

If an absolute pressure sensor is connected to the instrument, then
the device displays the true absolute pressure measured by the sen-
sor. This does not necessarily equate to the values given by weather
stations, which give the pressure at sea-level. Usually the sensor is
situated above sea-level and therefore, if the value at sea-level (zero)
is to be measured, the pressure loss resulting from the elevation above
sea-level must be considered! To correct the displayed value activate
the "Sea-Level-Function" (SL). Then enter the sensor's height above
sea-level in metres (Alti). When activated, the display shows the SL-
arrow and the device displays the absolute pressure value relative to
sea-level.

2.3 (rAtE) Choice of Measuring Rates: "rAtE-Slo, -P.dEt, -FASt"

Three options of measuring rate are supported. Two of them work with
high measuring frequencies of over 100 measurements per second.
Whichever one of them was selected during configuration (see above),
this will be displayed in the lower display: "P.dEt" or "FASt".
WIKA Operating Instructions Hand-Held Pessure Indicator
GB
13