Func-Stor": Storing Discrete Measurements - WIKA CPH6200-Ex Betriebsanleitung

Hand-Held Pressure Indicator
CPH6200-Ex (Atex-Version)
4.1 „Func-Stor": Storing discrete measurements
In this mode, each time the ´Store/Quit´ key is pressed a measure-
ment and its time stamp will be recorded. The data recorded can be
viewed either on the display (an additional menu item "REAd-LoGG" is
displayed when scrolling through the Configuration menu) or through
the serial interface and a PC running the GSOFT-software.
Max. number of measurements:
The data recorded includes the following values:
Current value at that data point

Min-Peak, Max-Peak since last data point

Time and date stamp of that data point

After each recording "St. XX" will be displayed for a short time. XX
represents the number of the data point.
If the logger memory already contains data:
When the ´Store/Quit´ key is pressed for 2 seconds, the option to
clear the logger memory will be displayed:
Use the ´Min´ or the ´Max´ key to display the required option. The
´Store/Quit´ key selects that choice.
If the logger memory is full, the display will show:
Viewing Recorded Measurements
Within the "LoGG-STOR" function the measurements can be viewed
directly on the instrument display as well as through a computer
("Func-CYCL" only allows for the data to be viewed on computer).
Press the ´Set/Menu´ key for 2 seconds: The first menu displayed is
now "rEAd-LoGG" (read logger data). By then pressing the ´Tare´ key,
the last measurement recorded will be displayed; pressing the ´Tare´
key again scrolls between the different values related to this data point.
Pressing the ´Min´ key or ´Max´ key selects different data points.
WIKA Operating Instructions Hand-Held Pessure Indicator
99
clear
all data points
clear the last
data point
GB
clear nothing
(cancel menu)
17