Slave Mode - Cameo MOVO BEAM 200 Bedienungsanleitung

CONFIGURE DMX START ADDRESS
Starting from the main display, press the rotary-push encoder to enter the main menu (MENU).
Select the menu item Control by turning and pressing the encoder. Turn the encoder to select
DMX and press the encoder again to confirm. Now select Address, confirm by pressing the
encoder and then select the desired DMX start address again by turning the encoder. Confirm your
selection by pressing the encoder.
CONFIGURE DMX MODE
Starting from the main display, press the rotary-push encoder to enter the main menu (MENU).
Select the menu item Control by turning and pressing the encoder. Turn the encoder to select
DMX and press the encoder again to confirm. Now select Channel Mode, confirm by pressing
the encoder and then select the desired DMX mode again by turning the encoder. Confirm your
selection by pressing the encoder.

SLAVE MODE

Starting from the main display, press the rotary-push encoder to enter the main menu (MENU).
Select the menu item Control by turning and pressing the encoder. Turn the encoder to select
Slave and press the encoder again to confirm. To activate slave operation, select Yes and confirm
by pressing the encoder. To deactivate, select No and also confirm by pressing the encoder.
Connect the slave and the master units (same model, same software version) with a DMX cable
and enable a scene in the master unit in the standalone mode Scenes (Run Scene 1–8/Master/
Alone ->Master). The slave unit will now follow the master unit.
14