Cameo MOVO BEAM 200 Bedienungsanleitung Seite 13

OPERATION
PLEASE NOTE
As soon as the spotlight is correctly connected to the power supply, the following will be displayed
in succession during the start-up process: "Software update ...Please wait" (for service purposes
only), the software version, then "Welcome to Cameo" and "Reset". After this process, the spotli-
ght is ready for operation and the previously selected mode will be activated.
Note regarding the main display in operating modes with external control: As soon as the control
signal is interrupted, the characters in the display begin to flash. When there is a control signal
again, the flashing stops.
MAIN DISPLAY
The main display shows different operating mode-relevant information and information on the
device status in the different operating modes.
DMX operating mode Slave mode
Operating
mode
DMX start address Operating
mode
DMX operating
mode
Temperature of the LED unit Fan mode Temperature of the LED unit Fan mode
Standalone mode Scene
Operating
mode
Operating
mode
and
Scene
Temperature of the LED unit Fan mode
Temperature of the LED unit Fan mode
13