Technical Data - Scheppach 5906142901 Original Bedienungsanleitung

11. Avoid inadvertent starting
- Make sure that the switch is switched off when
plugging the plug into an outlet.
12. Use extension cables for outdoors
- Only use approved and appropriately identified
extension cables for use outdoors.
- Only use cable reels in the unrolled state.
13. Always remain attentive
- Pay attention to what you are doing. Remain
sensible when working. Do not use the power
tool when you are distracted.
14. Check the power tool for potential damage
- Protective devices or other parts with minor
damage must be carefully inspected to ensure
that they function correctly and as intended
prior to continued use of the electric tool.
- Check whether the moving parts function
faultlessly and do not jam or whether parts are
damaged. All parts must be correctly mounted
and all conditions must be fulfilled to ensure
fault-free operation of the electric tool.
- Damaged protective devices and parts must be
properly repaired or replaced by a recognised
workshop, insofar as nothing different is
specified in the operating manual.
- Damaged switches must be replaced at a
customer service workshop.
- Do not use any faulty or damaged connection
cables.
- Do not use any electric tool on which the switch
cannot be switched on and off.
15. Have your power tool repaired by a qualified
electrician
- This electric tool conforms to the applicable
safety regulations. Repairs may only be
performed by an electrician using original spare
parts. Otherwise accidents can occur.
16. Attention!
- For your own safety, only use accessories and
additional equipment that are indicated in the
operating manual or have been recommended
or indicated by the manufacturer. Use of other
tools or accessories that those recommended
in the operating manual or in the catalogue
could represent a personal danger to you.
17. Noise
- Wear hearing protection when using the
compressor.
18. Replacing the connection line
- If the connection line is damaged, it must be
replaced by the manufacturer or an electrician
to avoid danger. There is a risk of electric shock.
19. Filling tyres
- Directly after inflating tyres, check the pressure
with a suitable pressure gauge, for example at
your filling station.
20. Street-legal compressors in construction site
operation
- Ensure that all hoses and fixtures are suitable
for the maximum permissible working pressure
of the compressor.
21. Set-up location
- Only set up the compressor on a flat surface.
22. In case of pressures above 7 bar, it is
recommended to equip supply hoses with a
safety cable (e. g. a wire rope).
23. Avoid over-stressing the piping system by using
flexible hose connections to prevent kinking.
24. Use a residual current circuit breaker with a
trigger current of 30 mA or less. Using a residual
current circuit breaker reduces the risk of an
electric shock.
m WARNING! This electric tool generates an elec-
tromagnetic field during operation. This field can im-
pair active or passive medical implants under certain
conditions. In order to prevent the risk of serious or
deadly injuries, we recommend that persons with
medical implants consult with their physician and the
manufacturer of the medical implant prior to operat-
ing the electric tool.

6. Technical data

AC mains power connection
DC connection
Motor rating W
Operating mode*
Compressor speed
Operating pressure
Theoretical intake capacity l/min
Effective output rate at 1 bar
Protection type
Protection class
Weight in kg
AC cable length
DC cable length
Hose length
*S3 25% = periodical intermediate duty with a duty
cycle of 25% (2.5 min based on a 10 minute period)
The noise emission values were measured in accord-
ance with EN ISO 3744.
www.scheppach.com
220-240 V~
50 Hz
12 V
max. 150
S3 25%
4200 min
-1
ca. 8 bar
ca. 36,5
ca. 18 l/min
IP30
II
1,6
1,8 m
4 m
600 mm
GB | 19