Technical Data; Residual Risks; Unpacking; Before Starting The Equipment - Scheppach 5906142901 Original Bedienungsanleitung

6. Technical data

AC mains power connection
DC connection
Motor rating W
Operating mode*
Compressor speed
Operating pressure
Theoretical intake capacity
l/min
Effective output rate at 1 bar
Protection type
Protection class
Weight in kg
AC cable length
DC cable length
Hose length
Subject to technical modifications!
*S3 25% = periodical intermediate duty with a duty cy-
cle of 25% (2.5 min based on a 10 minute period)
The noise emission values were measured in accord-
ance with EN ISO 3744.
Wear hearing protection.
The effects of noise can cause a loss of hearing.
Noise data
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
Sound power level L
wA
Sound pressure level L
pA
Uncertainty K
wA/pA
7.

Residual risks

Comply with the stipulated maintenance and safety in-
structions in the operating instructions. Remain atten-
tive at all times when working and keep third parties at
a safe distance from your work area.
24 | GB
Even when the device is being used properly, there will
always be certain residual hazards that cannot be com-
pletely ruled out. The following potential hazards can
220-240 V~ 50 Hz
arise due to the type and design of the device:
12 V
• Unintentional starting up of the product.
• Damage to hearing if the stipulated hearing protec-
max. 150
S3 25%
• Dirt particles, dust etc. can get into the eyes or face
4200 min
-1
• Inhaling swirled up particles.
ca. 8 bar

8. Unpacking

ca. 36,5
ca. 18 l/min
m ATTENTION!
The device and packaging materials are not toys!
IP30
Children must not be allowed to play with plastic
II
bags, film and small parts! There is a risk of swal-
1,6
lowing and suffocation!
1,8 m
• Open the packaging and remove the device care-
4 m
600 mm
• Remove the packaging material as well as the pack-
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
• If possible, store the packaging until the warranty
9.
• Before you connect the equipment to the mains sup-
• Check the equipment for damage which may have
• Install the compressor near the point of consumption.
• Avoid long air lines and supply lines (extension ca-
90 dB
• Make sure that the intake air is dry and dustfree.
75,9 dB
• Do not install the compressor in a damp or wet room.
2,36 / 3 dB
• The compressor may only be used in suitable rooms
• The compressor is designed to be used in dry
www.scheppach.com
tion is not worn.
despite wearing safety goggles.
fully.
aging and transport bracing (if available).
port damage.
period has expired.

Before starting the equipment

ply make sure that the data on the rating plate are
identical to the mains data.
occurred in transit. Report any damage immediately
to the transport company which was used to deliver
the compressor.
bles).
(with good ventilation and an ambient temperature
from +5 °C to 40 °C). There must be no dust, acids,
vapors, explosive gases or inflammable gases in the
room.
rooms. It is prohibited to use the compressor in are-
as where work is conducted with sprayed water.