Technical Data - Scheppach HC85V Original Bedienungsanleitung

4. Do not heat paints and solvents. Risk of explosion!
5. If harmful liquids are processed, filter devic-
es (face masks) are required for protection.
Also observe the information on protective meas-
ures provided by the manufacturers of such sub-
stances.
6. The information and labelling of the hazardous
substances ordinance affixed to the outer packag-
ing of the processed materials must be observed.
If necessary, take additional protective measures,
in particular wear suitable clothing and masks.
7. Do not smoke during the spraying process or in the
working area. Risk of explosion! Paint vapours are
also highly flammable.
8. Fireplaces, naked flames lights or sparking ma-
chinery must not be present or operated.
9. Do not store or consume food or drinks in the work
area. Paint fumes are harmful to health.
10. The working area must be larger than 30 m³ and
sufficient air exchange must be ensured during
spraying and drying.
11. Do not spray into the wind. Always observe the
regulations of the local police authorities when
spraying flammable or hazardous spraying mate-
rials.
12. Do not use media such as white spirit, butyl al-
cohol and methylene chloride in conjunction with
the PVC pressure hose. These media destroy the
pressure hose.
13. The work area must be separated from the com-
pressor so that it cannot come into direct contact
with the working medium.
Operation of pressure vessels
• Anyone who operates a pressure vessel must keep
this in good working order, operate and monitor it
correctly, perform the necessary maintenance and
servicing works immediately and implement safety
measures as required according to the circumstanc-
es.
• The regulatory authority can instruct necessary
monitoring measures in individual cases.
• A pressure vessel must not be operated if it exhibits
a defect that poses a danger to personnel or third
parties.
• Check the pressure vessel for rust and damage
each time before use. The compressor shall not be
operated if the pressure vessel is damaged or rusty.
If you discover damage, please contact the custom-
er service workshop.
22 | GB
Warning!
This power tool generates an electromagnetic field dur-
ing operation. This field can impair active or passive
medical implants under certain conditions.
In order to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the power tool.
Ensure careful storage of the safety instructions.
Residual risks
The machine has been built according to the state-of-
the-art and the recognised technical safety require-
ments. However, individual residual risks can arise
during operation.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been met,
some non-obvious residual risks may still remain.
• Residual risks can be minimised if the "Safety In-
structions" and the "Intended Use" together with the
operating manual as a whole are observed.
• Avoid accidental starting of the machine: the oper-
ating button may not be pressed when inserting the
plug in an outlet. Use the tool that is recommended
in this operating manual. This is how to ensure that
your machine provides optimum performance.
• Keep your hands away from the working area when
the machine is in operation.

6. Technical data

Mains power connection
Engine output
Operating mode
Compressor speed
Pressure vessel volume
Operating pressure
Theo. Suction capability
Theo. Power output
Protection category
Device weight
Max. installation altitude
(above sea level)
Technical changes reserved!
www.scheppach.com
230 V~ 50 Hz
1600 W
S3 25%*
13800 min
-1
approx. 80 l
max. 14 bar
approx. 330 l/min
approx. 170 l/min
IP 32
44 kg
1000 m