Care Instructions; Maintenance; Backflushing; Exchanging The Filter Medium - Steinbach Comfort 50 Originalbetriebsanleitung

Care instructions

The filter system cannot filter out algae, bacteria and other microorganisms.
- Use special water care substances to prevent and remove these to ensure hygienically clean
water.
- Consult an expert and observe the dosage.

Maintenance

Backflushing

Backflushing regenerates the filter and the filter sand. The filter sand must cleaned prior to the initial
start-up and in regular intervals while in use.
Do not backwash when using Steinbach Filter Balls. If the filter throughput decreases, we
recommend washing the filter balls by hand. If necessary, exchange the filter balls.
1. Switch off the pump
2. Connect the backwash line (see section "Connecting the backwash line").
3. Press and hold down the valve lever
4. Set the valve lever to the "RÜCKSPÜLEN" (BACKFLUSH) position and release it.
The level engages at the "Rückspülen" (Backflush) position.
5. Switch on the pump
6. Backwash the system until clean water emerges from the backwash line (max. 2 minutes).
7. Switch off the pump
8. Press and hold down the valve lever
9. Set the valve lever to the "NACHSPÜLEN" (RINSE) position and release it.
The level engages at the "Nachspülen" (Rinse) position.
10. Switch on the pump
11. Let the pump run for 20 to 30 seconds to remove any residue in the valve head.
12. Switch off the pump
The valve head is still in the "Nachspülen" (Rinse). Make sure that to set the valve head to the
desired position, e. g., "Filtern" (Filter), after reactivating the pump.
The backwashing is completed.

Exchanging the filter medium

The filter medium used (quartz filter sand or Steinbach filter balls) should be exchanged
every 2 to 3 years, depending on the operating period and the amount of dirt on the
device.
1. Switch the pump
10
2. Close the shut-off valves or block the water flow to the pool's connecting hoses.
3. Screw in the drainage opening
4. Completely drain the water from the filter vessel
5. Screw the drainage opening into the filter vessel.
6. Remove the locking ring
7. Put aside the locking ring and its screws.
8. Slowly turn the filter vessel on its head and remove the quartz filter sand or the filter balls.
by pressing the ON/OFF button on the timer
10
on the valve head
35
by pressing the ON/OFF button on the timer
10
by pressing the ON/OFF button on the timer
10
on the valve head
35
by pressing the ON/OFF button on the timer
10
by pressing the ON/OFF button on the timer
10
off by pulling the power plug.
so that it comes out of the base of the filter vessel
27
by unscrewing the wing nut
2
.
37
.
1
.
37
.
37
.
1
.
37
.
37
via the drainage opening.
6
counterclockwise.
5
.
6
37