Preparing The Filter Vessel; Fitting The Line Connections - Steinbach Comfort 50 Originalbetriebsanleitung

Preparing the filter vessel

4
31
1. Fill the filter vessel
31
2. Fill the filter chamber
Please refer to the section "Technical data" for the required quantities.
Make sure that no filter medium gets into the clean water chamber
3. Insert the vessel seal
seal.
4. Align the notch on the outer edge of the
valve head with the adjustment lug of the
1
filter vessel.
5. Place the valve head on the filter vessel.
6. Place the locking ring
head and filter vessel connecting point.
7. Insert the locking ring bolt
hexagon socket of the locking ring.
8. Pass the locking ring bolt through the hole on
the opposite side of the clamping ring.
9. Place the wing nut
5
turn it clockwise to tighten it.
The filter vessel is prepared.

Fitting the line connections

Some hoses, such as the pressure hose, are very stiff. Place them in the sun before use
so that the heat makes them more flexible.
Only hand-tighten all screw connections. Excessive tightening of the screw connections
damages gaskets and plastic components.
Use suitable pool hoses Ø 32 / 38 mm for the described connections. Other pool hoses (such as INTEX
with threaded connection) require additional adapters. For the matching adapters, visit our web shop at:
www.steinbach-group.com
34
5
30
approximately 1/3 with water.
with filter medium.
30
. Check for any foreign objects in the groove and for the correct fit of the
3
around the valve
2
into the
4
onto the thread and
.
31
6
2
4
3
5
1