Installation And Commissioning; Assembly - Wessamat Cube-Line IC 70 EL Bedienungsanleitung

Operationg manual - English

5. Installation and commissioning

! CAUTION
When working on or inside the machine, note that the sheet metal parts used are sometimes
sharp-edged and you can injure yourself. Wear suitable protective gloves!
Follow the instructions below during assembly and installation to ensure optimum functioning of the ice cube
maker:

5.1 Assembly

Make sure that the installation site is firm and level and that there is good ventilation.
The installation area must withstand the weight loads.
The installation height should be at least 100 mm above the drain or funnel siphon.
Do not sit or stand on the ice maker! Do not place any objects on the device!
Do not lift the ice maker by the ice removal flap!
ADVICE:
Under certain environmental conditions (e.g. high ambient temperature and / or high air humidity) condensation can
form in the area of the ice maker.
The ice cube maker must not be operated in the following environments:
•
atmosphere subject to explosion hazard,
•
toxic atmosphere,
•
damp rooms.
Direct heat sources such as ovens, dishwashers etc. will impair the performance of the ice cube maker and
increase the cleaning effort and energy consumption.
! CAUTION
Always handle the box or the unpacked device or the individual modules in pairs!
5.1.1 Unpack the machine after delivery. (Please keep
the packaging in case you have to return the machine for
servicing.) Prior to installation, please remove the white
protective foil from the covering panels.
IC135 ECL, ECW only:
Place the ice maker module on the combi module (see
Fig. 2), making sure that the holes of the ice maker
module are exactly above the screw heads of the combi
module. Connect the communication plugs of the ice
maker module with the respective ones of the combi
module using the
associated cables (see
Fig.4 and Fig.6).
5.1.2 Set up the device
absolutely horizontally. Use
the adjustable feet for
alignment (see Figure 1).
NOTE:
All connection work must be carried out in accordance with the applicable regulations! Please also note the
technical data and application conditions, chapters 4.3 and 4.4.
Always use the hoses, connections and cables supplied with the device for installation!
Operating-Manual-CubeLine-v.01
+
-
Fig.1: Adjustable feet
80
Ice maker
unit
Screw
head
Combi-
unit
Fig.2: Mounting IC135 ECL, ECW
Srew head
01/2021