Pre-Commissioning Check; Commissioning; Ice Production - Wessamat Cube-Line IC 70 EL Bedienungsanleitung

Operationg manual - English

5.6 Pre-commissioning check

Prior to first commissioning and after prolonged periods of non-operation (e.g. company holiday or transport) the
ice cube maker should be cleaned (see chapter 7.1), and checked and its proper function testified by a specialist.

5.7 Commissioning

Open the water shut-off valve and start the ice cube maker (switch the production switch in position "Produktion
ein/on"). Ice cube production starts automatically.
! CAUTION
The ice made from the first cycle of production is not adequat for consumption. And must be
evacuated from the storage unit.

5.8 Ice production

The ice maker produces ice until the storage container is
full. The level of ice in the storage container is
automatically regulated by a thermostat. When the
maximum level in the storage container is reached, ice
production is automatically terminated and automatically
restarted after a corresponding amount of ice has been
removed.
IC135 ECL, ECW only:
For machines with a split storage container, the selected
type of ice (cube or crushed ice) is always produced first
and then the other part of the storage container is
automatically filled. If ice is removed from the priority part,
it is refilled.
Production can be ended at any time by pressing the on /
off button once.
However, briefly switching the ice maker on and off should
be avoided!
! ATTENTION
The ice cream from the first production cycle is not
suitable for consumption for reasons of hygiene
and must be removed from the storage container.
Operating-Manual-CubeLine-v.01
On/Off
switch
Front-
sheet
Storage
bin
Ice-
withdrawal
flap
Ventilation grille
Fig.9: Front view IC130
85
Inlay
sheets
01/2021