Disposal; Disposal Instructions - Wessamat Cube-Line IC 70 EL Bedienungsanleitung

Operationg manual - English
Ice cubes are milky or
misshapen.
Ice maker has too little ice
output.
Storage bin is overflowing
with ice..
There is water in the storage
tank.
The elimination of other malfunctions should only be carried out by a specialist or a service employee of an
authorized WESSAMAT specialist dealer.

8 Disposal

8.1 Disposal instructions

If the machine would be put out of service, please follow the instructions below for disposal:
The refrigerant circuit of the ice cube maker contains R290/R449A and lubricants that
pollutes the water!
The machine must therefore be disposed of properly according to the relevant environmental
protection regulations. Should you have no options for proper disposal, please contact your
specialist dealer or WESSAMAT directly.
Operating-Manual-CubeLine-v.01
nozzles are frozen over.
Production time is too long, injection
nozzles are frozen over.
Water level too low.
Ventilation is not sufficient.
Room / ambient temperature is too
high.
Water inlet temperature too high.
The fins on the condenser are dirty.
Injection nozzles are calcified.
Storage tank thermostat does not
switch off.
The storage container drain hose is
kinked or blocked.
101
production time (see Chapter 6.2).
Allow injection nozzles to thaw, reduce
production time (see Chapter 6.2).
Contact specialist dealer or
WESSAMAT service.
Maintain the specified minimum
distances and ensure optimal air
circulation.
Lower the room / ambient temperature,
change the location of the machine if
necessary, replace the air-cooled
machine with a water-cooled machine if
necessary.
ensure a cooler water supply.
Clean the condenser.
Perform cleaning.
Check storage tank thermostat.
Ensure that the water runs off freely.
01/2021