Operation - Cameo ZENIT W600 SMD Bedienungsanleitung

• If one of the DMX operating modes is activated and there is no DMX signal to the DMX input, the
currently programmed DMX address is displayed and the characters on the display will begin to
flash.
• Press MODE to go up one level in the menu structure. To go to the main display in the menu
structure, press MODE repeatedly.
• The main display is activated automatically if there is no input in the space of approximately one
minute.
• Fast Access Feature: In order to simplify the menu guide, the device has an intelligent menu
structure that allows direct access to previously selected menu items and submenu items.
1. Press MODE and ENTER simultaneously for direct access to the last-edited submenu item,
where you can make changes instantly as required (DMX starting address and all modes).
2. Press MODE to go directly to the last selected and edited menu item. If you now repeatedly
press ENTER, you can access the submenu items to make individual settings (DMX start address
and all operating modes).
• The display can be rotated through 180° by pressing UP when the main display is visible.
• To quickly change a value (e.g. DMX start address), press and hold the UP or DOWN button.
CAUTION: In order to provide protection from spraying water, in accordance with
protection class IP65, special IP65-rated XLR connectors must be used correctly
with the DMX input and output sockets, or they must be closed using the rubber
sealing caps. When connected correctly, or when sealed correctly with the rubber
sealing caps, the POWER IN and POWER OUT sockets are protected from spraying
water, as in accordance with IP65.

OPERATION

MAIN DISPLAY
The main display shows the following information: Current mode (in the example: DMX mode with
start address 001) and W-DMX™ status.
W-DMX™ status
DMX Address
001
Current operating mode
13