Cameo ZENIT W600 SMD Bedienungsanleitung Seite 14

W-DMX™
To pair a W-DMX receiver with a W-DMX compatible transmitter
, the Reset command must be executed in the menu item WDMX under Receiver (select Reset and
confirm). The receiver is now in pairing standby and waiting for a pairing request from a transmit-
ter. Start the pairing by selecting Link in the menu of the transmitter and confirming; the pairing
now takes place automatically. In the same way, several receivers can be paired simultaneously
or one after the other to a transmitter (e.g. for master / slave operation). A W-DMX connection
is always maintained until the connection is disconnected by means of the Reset command in
the receiver or the Unlink command in the transmitter, regardless of whether a device has been
disconnected from the power supply in the meantime.
W-DMX™ STATUS
W-DMX™ W-DMX™
deactivated activated as
receiver,
not paired
SETTING DMX START ADDRESS (DMX address)
Press MODE to access the main menu (--- Menu ---). Using UP and DOWN, select the menu item
DMX Address (observe arrow) and confirm with ENTER. The display will show a three-digit num-
ber field and you can use the UP and DOWN controls to configure the desired DMX start address.
Confirm the entry with ENTER and press MODE to return to the main display (in the example,
„DMX address 001").
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
14
W-DMX™ W-DMX
activated as
activated and is
receiver and is paired to device,
paired to device, no DMX signal
Transmitter is
switched off or
out of range
001
- DMX Address
001
5xx
W-DMX™ W-DMX™ and
activated as transmission
receiver and is mode G3 is
paired to device, enabled
DMX signal is Up arrow =
present Send operation
Down arrow
= Receive
operation
Arrow flashes=
Pairing process
Flashing stops =
Paired
G3 G4S
W-DMX™ and
transmission
mode G4S
activated
Up arrow =
Send operation
Down arrow
= Receive
operation
Arrow flashes=
Pairing process
Flashing stops =
Paired