Cameo ZENIT W600 SMD Bedienungsanleitung Seite 19

TIMER FUNCTION (Timer)
The timer function allows the standalone modes Color Macro, Static, Tunable White and User
Color to be timer controlled in such a way that the fade-in time can be set from 0 to 60 minutes,
the dwell time from 1 to 24 hours and the fade-out time from 0 to 60 minutes. Time control starts
immediately after activating the timer function in the previously activated standalone mode and
remains active even if the spotlight is switched off and restarted.
Select Timer as per the procedure described above under CONFIGURE STANDALONE MODE and
confirm with ENTER. For the individual timer control settings, select Fade In, Dwell Time or Fade
Out and confirm with ENTER. The display will show a three-digit number field in each case. Use
UP and DOWN to set the value as required from 000 to 060 or 001 to 024. Confirm by pressing
ENTER again. Once all settings have been configured as required, activate the timer function by
selecting the submenu item Timer On/Off using UP and DOWN, confirm with ENTER, select On
and confirm again with ENTER (to deactivate the timer function, please select Off and confirm).
Please note: The timer function is suitable for use in master/slave mode via cable and W-D-
MX™.
SLAVE MODE CONFIGURATION
Press MODE to access the main menu (--- Menu ---). Using UP and DOWN, select the menu item
Slave (observe arrow) and confirm with ENTER. Connect the slave and the master units (same
model, same software version) with a DMX cable and enable a standalone mode on the master
unit. The slave unit will now follow the master unit. If there is no control signal, the display cha-
racters will flash. Flashing stops as soon as a control signal is present.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
Mode
Slave
19