Optional Accessories - Cameo ZENIT W600 SMD Bedienungsanleitung

PLEASE NOTE!For conversion or retrofit sets provided by the manufacturer, it is
essential to observe the installation instructions included.
CLEAN FAN
The three fans on the back of the LED unit of the spotlight must be regularly checked and, if
necessary, cleaned. Disconnect the spotlight from the power supply. Loosen the 4 socket screws
holding the fan cover to the LED unit using a suitable tool. Remove the fan cover from the LED
unit, clean the fans and check that the fans can rotate freely. If compressed air is used, care must
be taken to ensure that damage to the device is prevented (e.g. fans must be blocked in this case,
as they could otherwise over-rev). Clean the ventilation openings of the fan cover and fasten the
cover again with the previously loosened screws.
If a fan should become blocked despite cleaning, take the spotlight out of operation and contact
an authorised service centre.

OPTIONAL ACCESSORIES

CLZW6004B
Barn door – tool-free mounting
thanks to threaded locking bolts, safety cable included
26