Cameo ZENIT W600 SMD Bedienungsanleitung Seite 20

SYSTEM SETTINGS (Settings)
Press MODE to access the main menu (--- Menu ---). Using UP and DOWN, select the menu item
Settings (observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the following submenu items (see table, select with
UP and DOWN, confirm with ENTER, change value or status with UP and DOWN, confirm with
ENTER):
Settings
Wireless = W-DMX
Settings Settings
(Wireless DMX)
Display = flip display
Reverse
Display = Display lighting
Backlight
DMX Fail = Operating status
when DMX signal is
interrupted
20
W-DMX On/Off On = W-DMX activated
Off = W-DMX deactivated
Operating Receive = W-DMX module as receiver
Mode
Transmit = W-DMX module as transmitter
Transmitting G3 = G3 transmission standard
Mode
G4S = G4S transmission standard
Link Link = pair with W-DMX devices. W-DMX
must be activated on all devices and the
pairing must be picked up by a transmit-
ter (Receive Reset).
Unlink = decoupling of all devices
Receive No = Do not retain transmitter pairing
Reset
Yes = Retain transmitter pairing
On Rotate display by 180° (e.g. for overhead
installation)
Off No display rotation
On Permanently on
Off Deactivation after approximately 1 minute
of inactivity
Hold Last command is retained
Blackout Activates blackout
Full All the LEDs are 100%
Stand Alone Spotlight switches to the Static standalo-
ne mode