Connection To The Da40Ms02 Controls - Dürkopp Adler 271 Betriebsanleitung

6.3.2 Connection to the DA40MS02 Controls

1 2 3
–
Screw off the control cabinet.
–
Guide the cable of the sewing light transformer through the opening 1 at the back
of the controls.
–
Loosen screw 2 and remove cover 3.
–
Lay the cable through the guide 4.
–
Open terminals 5 and 6 with a screwdriver.
–
Connect the brown cable to terminal 5 and the blue cable to terminal 6.
–
Replace cover 3 again and fasten with screw 2.
–
Screw the control cabinet tight again.
4 5 6
GB
19