Changing Tools; Fitting The Sanding Sheet Onto The Sanding Plate; Operation; Switching On And Off - Parkside PMFW 310 D2 Originalbetriebsanleitung

Scraper Z52 A1
Materials
mortar/concrete residues, tile/carpet glue, paint/
silicone residues
Application
–
removal of material residues, such as tile
adhesive, when replacing damaged tiles

Changing tools

NOTE
► If you plan to use the dust collection unit, it
must be connected before fitting or changing
the tool (see section "Connecting a dust
extraction device").
WARNING! RISK OF INJURY!
■ Always remove the plug from the power
socket before working on the power tool.
■ Check that the tool is fitted firmly. Incorrectly or
insecurely fitted tools can come loose during
use and cause you an injury.
■ If necessary, remove an already fitted tool.
To do this, raise the tool release lever
■ Fit the tool (e.g. the plunge saw blade
the tool holder.
NOTE
► You can fit the tools in any snap position on
the tool holder.
■ Lock the tool into place by pushing the tool
release lever back down again.
│ GB │ MT
■ 44
Fitting the sanding sheet onto
the sanding plate
Attaching
♦ Sanding sheets
pad
fastening.
NOTE
► Before fitting a new sanding sheet
any dust and dirt from the sanding pad
► Note that the holes for dust extraction from
sanding sheet
aligned.
♦ Position the sanding sheet
of the sanding pad
sheet on the sanding plate.

Operation

Switching on and off
Switching on
♦ Push the ON/OFF switch
the appliance on.
Switching off
♦ Push the ON/OFF switch
switch the appliance off.

Selecting oscillation speed

♦ Use the speed adjustment wheel
required oscillation speed.
Level 1: low speed
.
Level 6: high speed
) onto
NOTE
► The required speed depends on the material
being worked and on the working conditions
and can be determined through practical
tests.
are attached to the sanding
by means of the hook and pile
and sanding pad
flush on one side
, then place the sanding
forwards to switch
backwards to
PMFW 310 D2
, remove
.
are
to set the