Before Startup; Moving Sweeper Without Engaging Self-Propulsion - CONQUEST PB120LPG Bedienungsanleitung

Indicator lamps and display
Illustration
1 Operating hour counter
2 Charge warning lamp
3 Oil pressure warning lamp
4 Cooling water temperature warning
lamp
5 Motor suction air
6 Warning light parking brake operated
7 Forward travel direction
8 Direction of travel reverse
9 Indicator light parking light/low beam
(option)
10 Warning lamp fuel reserve
- blinks for reserve
- illuminates when gas bottle is empty

Before Startup

Lock/ release parking brake
 Loosen parking brake; press brake
pedal at the same time.
 Activate the parking brake; press brake
pedal at the same time.
Moving sweeper without engaging
self-propulsion
Note
This procedure is necessary if the device
needs to be pushed off the palette or towed
away, or must be moved onto a transport
vehicle without its own drive.
ATTENTION
Do not move the machine for long distanc-
es without engaging self-propulsion; a
speed of 10 km/h should not be exceeded.
1 Screw
2 Key
 Unscrew the screw.
 Remove the spanner.
24
1 Hydraulic pump
2 Key
3 Nut
 Loosen the nut using the spanner (open
freewheel) until the device can be
pushed.
 IMPORTANT: Once pushed, reclose
the nut (close freewheel = drive posi-
tion).
Start up
General notes
 Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.
 Park the sweeper on an even surface.
 Remove ignition key.
 Lock parking brake.
Install/replace gas bottle
Warning
Only use replacement cylinders with 11 kg
contents of tested models.
Danger
Risk of injury!
– Follow safety regulations for LPG vehi-
cles.
– Formation of crusts and yellow-frothing
deposits on the gas cylinder indicate
leakiness.
– Cylinders must be changed only by in-
structed persons.
– Cylinders containing propellant gases
must not be changed in garages and
underground areas.
– Do not smoke and use uncovered light
while changing the cylinder.
– While changing cylinders, first close the
locking valve of the LPG cylinder firmly
and immediately put the protective cap
on the empty cylinder.
Installing the gas bottle
ATTENTION
Observe the installation position of the gas
cylinder. The connection / ring opening
must point downwards.
6
-
EN
1 Gas cylinder
2 Safety rod
3 Bracket closure
 Release the screws on the safety rod
and pivot the pole away.
 Replace the gas cylinder.
 Unscrew the protective cap from the
connecting valve of the gas cylinder.
 Close the bracket closure.
Connecting gas cylinder
ATTENTION
After connecting the cylinder, regularly
check that it is not leaky by using a foaming
agent.
1 Protective cover
2 Gas hose with union joint
3 Gas withdrawal valve
 Screw the gas hose to the connecting
valve of the gas cylinder (30-mm span-
ner).
 Close the safety bar, and secure it with
a bolt.
Replacing the empty gas bottle
If the warning indicator for reserve fuel
shows an empty gas bottle continuously
during operation, proceed as follows:
 Close gas drawing valve by turning it in
clock-wise direction.
 Stop the the machine and continue to
run it at idle speed until the motor shuts
off.
Note: This will ensure that all gas lines
are empty and that there can be no ic-
ing which would hinder starting the mo-
tor.
 Unscrew the gas hose (30-mm span-
ner).
 Screw the protective cap onto the con-
necting valve of the empty gas cylinder.
 Open the cliplock.
NOTICE
Connection has a left threading.
Warning
Open the gas drawing valve (3) only after
starting the appliance (refer chapter Start-
ing the appliance).