Continuous Operation Unimax 1010, Promax 1020 - Heidolph Hei-MIX Unimax 1010 Betriebsanleitung

Operation

Continuous operation Unimax 1010, Promax 1020

In continuous operation, the shaking movement can be started and stopped manually
as required after switching on the device.
➜
Place the vessel(s) on the platform. Observe the instructions in section
"Attachments" on page 41.
➜ Ensure that the speed control is set to zero.
➜
Switch on the device (see "Switch the device on/off" on page 42).
➜ Press the two timer buttons (up/down) at the same time to set the timer to
➜ Press the start/stop button to activate the standby mode.
start/stop
– The
➜ Start shaking operation by increasing the intensity up to the desired value, using
the speed control.
– The shaking intensity (speed) is shown in the display.
➜ Stop the shaking movement by turning the speed control back to zero.
The shaking intensity (speed) can be adjusted at any time during
operation.
Speed
and LEDs light up.
44
000
: