Mounting; Pressure Peak Damping Option - HBM P8AP Bedienungsanleitung

Mechanical Construction
10
Swivel nut before tightening
Fig. 5.1 Principle of a screwed connection with cutting ring
5.2

Mounting

The transducer can be installed in any position, as re-
quired. If the transducer is used to measure dynamic
pressure characteristics in liquids, install it with the pres-
sure connection pointing upward, so that it not possible
for an air cushion to build up in the measurement tube
that could, for example, heat up unacceptably as a result
of dynamic loads.
 Push the swivel nut with seal onto the tube.
 Insert the tube into the connection piece of the
screwed connection.
 Tighten the swivel nut.
5.3

Pressure peak damping option

The pressure transducer may be damaged by applica-
tions with a dynamic overload. This is a particular prob-
lem in applications that are next to fast-closing valves or
close to hydraulic cylinders, where loading is spasmodic.
A2079-4.0
Tube of the P8AP
Swivel nut after tightening
P8AP