Commissioning; Factory Settings; Eco Display Mode; Network - flamco meibes MeiTronic LFC Montage- Und Bedienungsanleitung

Please pay special attention to the relay's technical information see " Specifications " on page 5.

Commissioning

Starting commissioning help guides you in the correct order through the basic settings necessary for commissioning, and
provides brief descriptions of each parameter in the display. Pressing the 'esc' key takes you back to the previous value so you
can look at the selected setting again or adjust it if desired. Pressing 'esc' more than once takes you back to the selection mode,
thus, canceling the commissioning help see " Commissioning procedure " on page 11
This may only be started by a specialist during commissioning! Observe the explanations for the individual parameters
in these instructions, and check whether further settings are necessary for your application.

Factory Settings

All settings can be reset, returning the controller to its delivery state.
All of the controller's parametrization, statistics, etc. will be lost irrevocably. The controller must then be commissioned
once again.

Eco Display Mode

In Eco Display Mode the backlight of the display is switched off, if no buttons are pushed for 2 minutes.
If a message exists, the backlight does not switch off until the message has been read by the user.

Network

If required, the network settings of the connected data logger must be set.
Access Control
This menu allows you grant access to up to 4 users to the data logger. The users that are registered then have access to the con-
troller or respectively the data logger.
To add a user in the list, select <add user>. Leave the now visible menu open and connect to the address of the controller or the
data logger. Your user name is going to appear in this menu and can be selected and confirmed by pressing 'OK'.
Note
You can find the address of the connector or respectively the data logger on the address sticker on the outside of the casing. You
can find tips and help on how to establish a connection in the enclosed SOREL connect instructions or the instructions of the data
logger.
Select a user by pressing 'OK' to grant access.
To revoke access again, choose one of the users from your list and select <remove user>.
Ethernet
The data logger's Ethernet connection settings can be set using this menu.
MAC Address
Displays the individual MAC address of the data logger.
Auto-Configuration (DHCP)
If auto-configuration is activated, the data logger requests IP addresses and network parameters from a DHCP server that
assigns an IP address, subnet mask, gateway IP and DNS server IP. If you deactivate the auto configuration (DCHP), you will
have to input the required network settings manually!
IP-Address
Please refer to the router configuration for the IP address to be set.
Subnetz
Please refer to the router configuration for the subnetz to be set.
17