Additional Information; Can Bus; External Relay On The Signal Output V(X); Tips - flamco meibes MeiTronic LFC Montage- Und Bedienungsanleitung

Additional Information

CAN bus

The CAN bus can be used to connect two or more controllers with each other or with the data logger to exchange data.
1. The controllers are connected in series with the CAN bus cable.
2. The first and last controllers in this series-connection must be fitted with a terminating
resist.
The wiring of the two CAN sockets is arbitrary.
3. Optionally, the data logger can also be connected to the CAN bus.
External relay on the signal output V(X) (0-10 V/PWM)
In order to use a 0-10 V/PWM output as a 230 V/AC switching output, an external
switching relay can be connected at the output V1, V2 or V3.
Then, the external relay is activated via the signal output (0 V = "off", 10 V = "on").
1. Connect the external 0-10 V relay to signal output, e.g. V1.
see " Relay functions " on page 16

Tips

The service values include not only current measurements values and operating states, but also all of the settings for the
controller. Write down the service values once after commissioning has been successfully completed.
In the event of uncertainty as to the control response or malfunctions, the service values are a proven and successful
method for remote diagnosis. Write down the service values at the time that the suspected malfunction occurs. Send the
service value table by fax or e-mail with a brief description of the error to the specialist or manufacturer.
To protect against loss of data, record any statistics and data of particular importance at regular intervals.
25